EnVision ST-JUMPER-12 – 12" Jumper Cable

Product Overview

The EnVision ST-JUMPER-12 is a 12-inch jumper cable accessory for EnVision 120V ARC FLEX striplight systems. It provides a short flexible connection between striplight runs or between a striplight and a compatible accessory or power point.

The ST-JUMPER-12 is part of EnVision’s accessory line for their 120V striplight family and is covered by the manufacturer’s 5-year limited warranty.

Key Features

• 12-inch jumper cable for EnVision 120V striplight systems
• Accessory for EnVision ARC FLEX 120V striplight product family
• Pairs with EnVision power cords, couplers, end caps, and mounting straps
• Manufacturer warranty: 5 Year Limited Warranty
• UPC: 819715025457

Function and purpose

The ST-JUMPER-12 is a 12-inch jumper cable used to connect sections of EnVision 120V ARC FLEX striplight or to bridge from a striplight run to a compatible accessory or power point. It provides a short connection option where a small gap or offset exists between components.

• Length: 12 inches (nominal)
• Used to join runs or connect a striplight to compatible accessories

Compatibility and system fit

The jumper is specified for EnVision’s 120V ARC FLEX striplight product family and accessories. Use the ST-JUMPER-12 with EnVision 120V striplight models and the accessories listed by EnVision.

• Intended for use with EnVision 120V ARC FLEX striplight (for example ST-2835-120V series)
• Pairs with accessories such as ST-POWSET power cords, ST-120-WP-COUP butt connector, ST-END-CAP end caps, and mounting straps

Environmental rating and applications

The EnVision ARC FLEX 120V striplight system is rated for wet locations (IP65) and has typical applications including cove lighting, under- and over-cabinet illumination, outdoor corridors, trees, and other residential or commercial striplighting needs. The jumper is an accessory for that system; the striplight system rating applies to the assembled system.

• System IP rating: Wet Location IP65 (not submersible)
• Suitable for the striplight applications listed by EnVision when installed per manufacturer guidance

Installation and related accessories

The ST-JUMPER-12 is an accessory component; plan installations using the full EnVision accessory set and follow EnVision’s installation guidance for wet-location sealing and maximum run lengths.

• Common accessories: ST-POWSET-18/36/72 power cords, ST-120-WP-COUP butt connector, ST-END-CAP end caps, 120V-STRAP-100PK mounting straps
• For outdoor installations EnVision notes sealing the power cord where recommended

Before You Order

Verify compatibility with your EnVision 120V ARC FLEX striplight model and confirm quantity before ordering.

• ST-JUMPER-12 is an accessory for EnVision 120V striplight systems; confirm the strip model and required jumper length
• If you need a different jumper length or other accessories, check EnVision accessory part numbers

Ordering from Lumera Electric

Check the purchasing options shown on the Lumera Electric product page for EnVision ST-JUMPER-12 – 12" Jumper Cable. For project quantities or additional ordering requirements, use Request a Quote and provide the required quantity.