Morris 14175 Aluminum EMT Set Screw Conduit Body T Type, 2"

Product Overview

The Morris 14175 is a 2" T‑type conduit body for EMT with set‑screw connections. Its die‑cast aluminum construction and flat back profile provide a durable access point for pulling, splicing, and maintenance.

Designed for use where conductors need to be accessed mid‑run, the body accepts a gasketed cover for rain‑tight installations and mounts close to walls for neat routing.

Key Features

• 2" trade size T‑type conduit body for EMT with set‑screw connections
• Die‑cast high‑strength aluminum construction
• Flat back design for mounting close to walls
• Accepts gasketed cover for rain‑tight protection when required

Function and intended use

The Morris 14175 provides a T‑type access point in an EMT conduit run to allow pulling, splicing, and maintenance of conductors. It is intended to be installed in the run of EMT where an intermediate access chamber is required.

• Allows pulling and splicing without disassembling conduit runs
• Set‑screw entries secure EMT conduit to the body

Typical applications

Use this conduit body at pull points, corners, and splice locations within an EMT conduit system. Its flat back makes it suitable for mounting close to walls or structural surfaces.

• Pull points in long conduit runs
• Splice locations where conductor access is needed
• Routing changes or intermediate junctions

Installation and mounting

Install the 14175 in the conduit run, secure EMT using the set screws, pull conductors through the body, then install the appropriate cover. A gasketed cover is used to achieve rain‑tight protection when required.

• Mount body flat against the wall for close clearance installations
• Use compatible gasketed cover to obtain rain‑tight rating
• Tighten set screws to secure EMT per conduit installation best practices

Materials and physical design

The body is die‑cast from a high‑strength aluminum alloy and features a flat back design. These attributes provide mechanical durability and a low‑profile mount for wall‑close installations.

• Die‑cast aluminum construction
• Flat back profile for neat mounting close to surfaces
• 2" trade size for EMT conduit systems

Before You Order

Confirm the model number and quantity required before ordering. Verify that a gasketed cover is specified separately if a rain‑tight installation is required.

• This listing is for the Morris 14175 conduit body (2").
• Gasketed covers or specific cover part numbers are not included unless ordered separately.

Ordering from Lumera Electric

Check the purchasing options shown on the Lumera Electric product page for Morris 14175 Aluminum EMT Set Screw Conduit Body T Type, 2". For project quantities or additional ordering requirements, use Request a Quote and provide the required quantity.